Oil & Gas Glossary 1.0

Injection of gases or liquids into a reservoir to force oil toward and into producing wells.

A method of improved recovery in which water is injected into a reservoir to remove additional quantities of oil that have been left behind after primary recovery. Waterflooding usually involves the injection of water through wells specially set up for water injection and the removal of water and oil from production wells drilled adjacent to the injection wells.

A poppet spring-loaded subsurface valve run in on wireline, landed in a profile, to shut the well if injection ceases.

A phenomenon that often occurs in an injection project in which the fluid being injected does not contact the entire reservoir but bypasses sections of the reservoir fluids in a finger-like manner. Fingering is not desirable, because portions of the reservoir are not contacted by the injection fluid.

An oil-recovery process which involves the injection of a solvent followed by a displacing fluid. - A method of secondary recovery of fluids from a reservoir by injection of fluids that are miscible with the reservoir fluids.

A method of improved oil recovery in which chemicals dissolved in water are pumped into a reservoir through injection wells to mobilize off left behind after primary or secondary recovery and to move it toward production wells. The chemical solution includes surfactants or surfactant-forming chemicals that reduce the interfacial and capillary forces between oil and water, releasing the oil and carrying it out of the pores where it has been trapped. The solution may also contain cosurfactants to match the viscosity of the solution to that of the oil to stabilize the solution and to prevent its absorption by reservoir rock. An electrolyte is often added to aid in adjusting viscosity. Injection of the chemical solution is followed by a slug of water thickened with a polymer, which pushes the released oil through the reservoir, decreases the effective permeability of established channels so that new channels are opened, and serves as a mobility buffer between the chemical solution and the final injection of water.

A method of improved recovery in which steam is injected into a reservoir through injection wells and driven toward production wells. The steam reduces the viscosity of crude off, causing it to flow more freely. The heat vaporizes lighter hydrocarbons; as they move ahead of the steam, they cool and condense into liquids that dissolve and displace crude oil The steam provides additional gas drive. This method is used to recover viscous oils. Also called continuous steam injection or steam flooding.

2. gas injected in gas lift operations.

Injection of nitrogen for gas lift valving.

An injection well used for injecting fluids into an underground stratum to increase reservoir pressure.

A well through which fluids are injected into an underground stratum to increase reservoir pressure and to displace oil.

A well into which gas in injected for the purpose of maintaining or supplementing pressure in an oil reservoir. More commonly called a gas injection well.

1. the activities and methods of preparing a well for the production of oil and gas or for other purposes, such as injection; the method by which one or more flow paths for hydrocarbons are established between the reservoir and the surface.

1.a high-pressure gas injected into a formation to maintain or restore reservoir pressure.

3. the device in a fuel-injection unit that regulates the amount of fuel pumped on each stroke.

2. the part of the fuel system of an engine that has small holes in it to permit fuel to enter the cylinder. Properly known as a fuel-injection nozzle, but also called a spray valve. The needle valve is directly above the nozzle.

A globe valve that contains a sharp, pointed, needle-like plug that is driven into and out of a cone-shaped seat to control accurately a relatively small rate of fluid flow. In a fuel injector, the fuel pressure forces the needle valve off its seat to allow injection.