Oil & Gas Glossary 1.0

A bradenhead pack; no packer, very limited pack pressure capability.

A type of gravel pack where the wells production packer is removed and a service packer is run in with the gravel pack assembly. After packing, the service tool is retrieved and the production packer rerun.

Slang for gas separator

(v) to place a packer in the wellbore and activate it so that it forms a seal between the tubing and the casing.

A mass of very fine gravel placed around a slotted liner in a well.

A packer used for the well completion method of gravel packing.

A preventer having a unit of packing material whose closure depends on well pressure coming from below. It is used primarily to strip pipe through the hole or allow pipe to be moved with pressure on the annulus.

Any method by which large amounts of sand in a sandy formation are prevented from entering the wellbore. Sand in the wellbore can cause plugging and premature wear of well equipment. See gravel pack, sand consolidation, screen liner.

(n) a device with an elastomer packing element that depends on pressure below the packing to effect a seal in the annulus. Used primarily to run or pull pipe under low or moderate pressures. This device is not dependable for service under high differential pressures. Also called a stripper.

A means of cementing casing in a well so that the casing may, if necessary, be retrieved with minimum difficulty. A special mud, usually an oil mud, is placed in the well ahead of the cement after the casing has been set. Non-solidifying mud is used so that it does not bind or stick to the casing in the hole in the area above the cement. Since the mud does not gel for a long time, the casing can be cut above the cemented section and retrieved. Casing packs are used in wells of doubtful or limited production to permit reuse of valuable lengths of casing.